Volvo CE 2014+ VILKUS-62: Granite edition. DPF/SCR-off solution

This product supports all Volvo CE machines equipped with one of the following engine:

• D3.3J, D4J, D6J, D8J, D9J
• D11J, D13J, D16J 
• L-series engines e.g. D13L
• Penta engines with SCR.

• No DPF/SCR related fault codes
• No derates under any working conditions
• Always low soot ratio
• NEW!!! Plug-n-Drop technology. No wires! Just plug it instead of ACM and enjoy! 
• HCDEA™ – HamCom Dynamic Emulation algorithm
• HCDMA™ – HamCom Direct Memory Access algorithm for total control of soot ratio values
• Reversibility

• Basic hand tools
• Multimeter and/or scope in case of troubleshooting
• Laptop with Tech Tool and communication interface for fault codes reading/erasing.

• Emulator module: sealed plastic box with 62-pin connector. Shockproof, waterproof dustproof, EMI-proof, non-serviceable electronic device.

• Check fault codes in EMS. Erase codes if necessary.
• Disconnect all NOx sensors from the machine. Trucks and machines may have different quantity of sensors. Please apply to your vehicle’s service manual.
• Unplug the connector from ACM module (MID233)
• Connect the VILKUS module instead of ACM
• Turn the key on and enjoy!

• Remove or drill DPF ceramic grids (this step is important, DPF grid may get totally clogged very shortly).

Warranty cases are:

• Device stopped working fully or partially during usage period

Non-warranty cases are:

• Mechanically cracked/broken device and/or device connector
• Removed stickers, serial numbers or trademarks
• Device abuse (high voltage, agressive moistures etc)
• Disassembling attempts
• Reverse engineering attempts and other copyright violations (may cause permanent blocking of your account)